Rear Wheel Bearing
#1
Rear Wheel Bearing
Some what new to the Ls400 but pretty mechanically inclined (Subaru, Turbo Buick, Semi trucks etc are what i usually work on)
Just wondering if someone has any insight of this because i was not finding a lot via Google and whatnot.
1998 LS400
just had the rear end up and was putting the wheel on, noticed some good slop in the wheel.
Wheel Bearing, i am fully sure of it.
I didn't get a super good look at it as it was starting to rain.
So question is,
Are the rear wheel bearings/ Hubs bolt in or Press in.
also how big of a PITA is it?
Thanks guys!
Just wondering if someone has any insight of this because i was not finding a lot via Google and whatnot.
1998 LS400
just had the rear end up and was putting the wheel on, noticed some good slop in the wheel.
Wheel Bearing, i am fully sure of it.
I didn't get a super good look at it as it was starting to rain.
So question is,
Are the rear wheel bearings/ Hubs bolt in or Press in.
also how big of a PITA is it?
Thanks guys!
#2
Some what new to the Ls400 but pretty mechanically inclined (Subaru, Turbo Buick, Semi trucks etc are what i usually work on)
Just wondering if someone has any insight of this because i was not finding a lot via Google and whatnot.
1998 LS400
just had the rear end up and was putting the wheel on, noticed some good slop in the wheel.
Wheel Bearing, i am fully sure of it.
I didn't get a super good look at it as it was starting to rain.
So question is,
Are the rear wheel bearings/ Hubs bolt in or Press in.
also how big of a PITA is it?
Thanks guys!
Just wondering if someone has any insight of this because i was not finding a lot via Google and whatnot.
1998 LS400
just had the rear end up and was putting the wheel on, noticed some good slop in the wheel.
Wheel Bearing, i am fully sure of it.
I didn't get a super good look at it as it was starting to rain.
So question is,
Are the rear wheel bearings/ Hubs bolt in or Press in.
also how big of a PITA is it?
Thanks guys!
Thread
Thread Starter
Forum
Replies
Last Post