i have a question since i was considering doing this. when you roll the fenders with that attachment or with the bat does it mess up the inner edge of the fender? what i what to know is does the paint crack from being rolled? if so then that would have to be repainted so it wouldn't rust out. NEO GEO

 

I used the bat just to bend it a little, but when the fender started to move a little I just used my arms instead of the bat.

 

I have been working on the height these past few days and this is how low it is now.

 

Ok i get it, your pic's look KOOL and i like the last one, your in the ball park now. NEO GEO

 

how does rolling the fenders make the car loweR?

 

Rolling the fenders makes it easier to tuck the wheel in the wheel well without having the wheels rub against it.

 

how do you tuck the wheel in?

 

the more you lower the car, the closer your wheels will be tucked into the fender.

notice the tuck in on the front wheel, you dont do anything to the wheel

 

So did you install lowering springs or what?

Don't tell me you have the JIC magic's

I would be so envious!

 

one last pic

Yes I have the JIC Magics

 

Eric, how the heck do you get on your driveway?
That thing is mad dumped man!!!

 

Good job Eric!!

 

eric... can't wait to see ur white devil in person~

 

How much overall drop from the stock height did you achieve so far? Is the car even driveable anymore?

 

Should be around 3 1/2 - 3 3/4 inches in the rear and and 3 1/8inches in the front. The car is driveable BTW