b16gsr

19x9 and 19x10.5.

mavisky

Willing to share offsets? I just ordered a set of 20x9 and 20x10.5 myself

b16gsr

Low 30s front and high 30s rear if I remember right. I would have to dig back through a ton of emails.

mavisky

Interesting as I'm high 20's rear high 30's front based upon the previous owner's configuration.

b16gsr

have any pics of previous setup? We are probably pretty close to the same. I am thinking it’s 30 or 31 front and 38 or 39 rear.

mavisky

This was the old setup on GTR wheel fenders have been trimmed front and rear on my car so you may not be able to go as aggressive if yours aren't.

20x9.5 F +40mm including spacers
20x10.5 R +25

My incoming setup is 20x9 +38 and 20x10.5 +27 which should sit a couple mm inboard both front and rear from what this setup was.

Ellesse

what finish is that? Gorgeous color!

b16gsr

brushed bronze shouldn’t look too bad in pearl white.

ZedRe4d

Just bought this a week ago and excited to start customizing it just a bit. Pristine, one owner, 36k miles!

ChopsGS

A few new pics in the sun with the new wheels/tires...

mavisky

New muffler delete went on. Have some nasty resonance in the 1600 to 2000rpm range and around the 125hz frequency. Designing a Helmholz resonator now to solve the issue hopefully.

ChopsGS

Same here with the interior drone. Let us know how the Helmholtz resonators work out, and the specs of them. I did a little research a while back and IIRC, it looked like you need them to be roughly 2.5" diameter and I think 26" to 30" long.

mavisky

What you're describing is a 1/4 wave resonator. I've looked into one of those but fitting one is tricky with the spacing available. Your memory serves you correct although diameter isnt as much of a concern as length. A true Helmholz resonator consists of a primary tube and a secondary larger chamber.

My calculations are showing I'll need a 1.5" od tube at a length of 5.5" with a larger second chamber comprised of a 4" od chamber with a length of 6". Im planning on fabricating these snd having them installed in the location of each of the rear mufflers.

ma61

Looks great!

Are those Celsior fog lights?
What have you done with the suspension, and whats the wheel and tire specs?

You're on the same wavelength as I am, looks like you've done everything I'm about to

ChopsGS

They're stock fogs, just with high quality, high output yellow LED bulbs. The tail lights are Celsior however.

I'm on Fortune Auto 500 Gen 7 coilovers. Wheels are 19x8.5 +40 w/ 245/40's.