brakes
#2
Sensor
The pad wear sensor has to be replaced. Once the sensor is tripped, the sensor either has to be replaced, or soldered and loop closed to turn the sensor "off." Check a recent thread on brake pad replacement to see what I'm talking about.
#3
Driver School Candidate
Thread Starter
Join Date: May 2009
Location: va
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
any one know how much brake sensor cost
#5
Driver School Candidate
Join Date: Dec 2008
Location: FL
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Along this thread- I just replaced my brake pads and sensors but am still getting the brake warning and little red exclamation mark flashing. I have reset the maintainence required warning, but the brake warning is still flashing. Any suggestions on how to reset it?
Thread
Thread Starter
Forum
Replies
Last Post
topgun129
LS - 1st and 2nd Gen (1990-2000)
2
10-14-09 01:41 PM