Is this offset Possible?
#1
Is this offset Possible?
Guys I have bad news.
I bought a set of Leon Hardiritt 19 inch 9 and 10 inch rims. I just found out the fronts dont clear the BBK. so I need spacers.
I have ordered 25mm offset but the rims at +24mm anyway This means my front rims will be -1mm offset
This is just crazy isnt it? Will this even fit?
I bought a set of Leon Hardiritt 19 inch 9 and 10 inch rims. I just found out the fronts dont clear the BBK. so I need spacers.
I have ordered 25mm offset but the rims at +24mm anyway This means my front rims will be -1mm offset
This is just crazy isnt it? Will this even fit?
#4
A 15mm spacer should do the trick. Just use a ruler and measure out from where the wheel would sit on the mounting pad to the brake caliper. If that distance is 14mm or less, then a 15mm spacer will work. I recommend going with H&R spacers since they are hubcentric, and if you don't mind changing out the wheels studs. If you don't want to change out the wheels studs, then go with Project KICS spacers. I suggest getting the Project KICS hubcentric adapters as well since the spacers aren't hubcentric like the H&Rs.
Trending Topics
#9
Well if you dont wanna pull, I guess you can go with like a 215 or 225 tire and roll it flat. If it rubs then camber in a bit more.
http://www.rimtuck.com/setup.php?id=465
20x9.5 +1 up front but fenders are pulled
http://www.rimtuck.com/setup.php?id=465
20x9.5 +1 up front but fenders are pulled
#10
Ah that looks good. Well i can pull my fenders a bit depending how much itll cost to respray them. Also if i go back to stock I dont want it to look funny.
How exactly do you roll a tyre flat. Currently I have 235 up front
How exactly do you roll a tyre flat. Currently I have 235 up front
#12
ohh lol oops haha..
Ok so i cut out a cd case and used it as a fake hub and a 15mm spacer should be good. Thanks for the advise above not to get the 25mm.
Now going from the link of the LS430 With low offsets i will roll fenders and stick in an inch or 2 of camber and it should be all good.
Ok so i cut out a cd case and used it as a fake hub and a 15mm spacer should be good. Thanks for the advise above not to get the 25mm.
Now going from the link of the LS430 With low offsets i will roll fenders and stick in an inch or 2 of camber and it should be all good.
Thread
Thread Starter
Forum
Replies
Last Post