paulrichmo

01 LS430 uninstalled all audio components.
But still blowing 30 amp audio fuse.
Any or all help appreciated! paulrichmo

02Legend

iTrader: (3)

Does the fuse blow immediately when you install it? If so, you have a short somewhere between power and ground.

paulrichmo

is there a logical place to look?

02Legend

iTrader: (3)

When you say uninstalled all audio components, are you referring to aftermarket or original? Regardless, check any connections you have done/undone and make sure there is no damage or intermittent connectivity. Any splices done to any wires where it could be rubbing ground somewhere?

paulrichmo

all original equipment no after market stuff.

paulrichmo

i`m plaged with weird popups on this site . m,akes it difficult. thanks to all!!

paulrichmo

no wires are spliced, all orig. equip.

paulrichmo

i`ll be back tomorrow

paulrichmo

Thank you, this is great info. Exactlly what s needed, I`ll be back

paulrichmo

I
n the upper right hand hip of truunk there is the followin components.
panasonic rechargab L_T122PU battery
a unit about the same size that has anntenna plug in phone jack ear phoe jack small 4 pin plug in
the big one is 1x5x10 and assume it is amplifier. has two jacks one with1 pin and the biggeee has30 2 pins.
Question Is the lite blue red wire in thew bbig plug or one of the small ones??


There is also the GPS box and an am fm tuner box these are at bottom right side.

All the wires are wrapped in bundles and outwardly aappear ok.
I am not in a big hurry on this not wanting to make things possible worse!!
Looking forward to some more of your good advice. Sincerely paulrichmo

paulrichmo

Thanks again. I did uninstal all components to make sure it was a conducter problem.
there is only one Blacup front fdor seat warmers.
All other connectors are white none close in appearance to the drawing you sent.
There is one 32 point connecter plug and one single pin.
will separate the wires to the 32 pin plug and start tere.

paulrichmo

The amp has the 32 pin plug and a single

paulrichmo

all components are sitting on the work bench.
I have blown 5 30 amp fuses so far.
I will unwrap the bundle to the 32 pin p[lug and start there.
I will be back, and Thank you.

paulrichmo

I dont know how to do pictures!

paulrichmo

there is a single shieldedblack wire with a blue connector that seems to be shorted.
This quite possibly be the feeder? Im working outside in t TOO HOT he driveway and th sun caught me, Will ck it in morning. Thanks for interest and help!!