Auction LS restoration
#91
Advanced
Thread Starter
Hood still isn't done, took a break and to be honest I'm a little discouraged at the moment. I body filled all the dings but I can still feel them. I'm going to spend the extra 50 bucks and spray some high build primer so I can tell what needs work.
#92
Moderator
You'll get there...
#93
Advanced
Thread Starter
Thanks. I put down 4 coats of high build primer and I it looks pretty good. Just need to block sand and do a final thinner coat of primer.
#94
Advanced
Thread Starter
Good news, the hood leveled out. Going to make one more wetsand pass with 600 grit and it will be ready for paint.
#95
Advanced
Thread Starter
Did some minor glazing to make the hood perfectly level. Definitely ready for paint now. Next post will be of the car assembled.
#96
Moderator
It's gonna look great when you're done. Now if you can keep the bugs out of the paint while it's drying....
#98
Advanced
Thread Starter
I plan to paint the hood tomorrow morning. So far I've be lucky with bugs or any debris.
Thanks King, I just checked out your build and your car looks awesome.
I washed the car tonight, it was filthy from sanding dust and wetsanding.
Thanks King, I just checked out your build and your car looks awesome.
I washed the car tonight, it was filthy from sanding dust and wetsanding.
#100
Moderator
Fender liner looks like it's been coated with Armorall !
#101
Advanced
Thread Starter
Yeah, I just sprayed degreaser and used a pressure washer.
So the hood is done and that is about all I can say lol. I will be getting it professionally done later. My body work and the hood had too many disagreements.
So the hood is done and that is about all I can say lol. I will be getting it professionally done later. My body work and the hood had too many disagreements.
#102
Advanced
Thread Starter
Got the hood wetsanded with 1500 grit, looks like it will level out decent. At least the orange peel is gone. I wont know how it look until I do the finer grits and compound+polish. So it wasn't a total failure.
#103
Moderator
you'll get it right.. A little buffing will go a long way.. Nice job so far.
#104
Advanced
Thread Starter
Thanks. The hose I was using to keep the floor wet is very old and with the nozzle off it split and sprayed water everywhere lol. I can't be mad though. I polished out a section, it is acceptable for now. Got a quote from a friend to get it fixed later. Got the gaps and headlights massaged. Passenger headlight need to be pulled apart and resealed. My fault since I tried to reuse the original gasket.
#105
Advanced
Thread Starter
Almost done, just need to finish wetsanding the hood and a few spots on the bumper and fender, then polish.