Gasket IDs needed
#1
Driver
Thread Starter
Gasket IDs needed
Going to do the valve covers, and I've watched a couple of YouTube videos. I've noticed a couple of gaskets that the videos never show as being replaced. Can anyone give me the part numbers? The exploded diagrams aren't clear enough for me to be certain. Or, perhaps I'm not looking at the right thing
Also, it looks like I somehow didn't set the fuel pump gaskets correctly when I replaced them, or the generic parts failed. I'm still getting a slow leak. I'm going to get the whole kit from Bell Toyota on eBay. Anything other gaskets I'm missing? Anything I should get extras of just in case?
Thanks all.
Also, it looks like I somehow didn't set the fuel pump gaskets correctly when I replaced them, or the generic parts failed. I'm still getting a slow leak. I'm going to get the whole kit from Bell Toyota on eBay. Anything other gaskets I'm missing? Anything I should get extras of just in case?
Thanks all.
#2
Lexus Fanatic
This site has clean diagrams
http://www.japan-parts.eu/
Looked at a few diagrams don't think I saw those particular gaskets.
http://www.japan-parts.eu/
Looked at a few diagrams don't think I saw those particular gaskets.
The following users liked this post:
eelliiss (08-28-21)
#3
Pole Position
Part numbers for those parts are 111590S010, 90430-A0001, and 111590P010. You will need two of each. I always double check part numbers with a Lexus dealer before ordering. I recommend to you do the same.
Make sure you clean all surfaces before installing new gaskets. I strongly recommend to use clean oil to lubricate gaskets before installing. The engine surface that comes in contact with gaskets must be spotless. Also, under no condition, scratch metal the surfaces that come in contact with gaskets.
Make sure you clean all surfaces before installing new gaskets. I strongly recommend to use clean oil to lubricate gaskets before installing. The engine surface that comes in contact with gaskets must be spotless. Also, under no condition, scratch metal the surfaces that come in contact with gaskets.
Last edited by Anfanger; 08-28-21 at 05:29 AM.
The following users liked this post:
eelliiss (08-28-21)
Thread
Thread Starter
Forum
Replies
Last Post
Modenaro
Performance & Maintenance
12
09-10-17 10:47 AM
CF01
ES - 1st to 4th Gen (1990-2006)
8
12-26-15 02:03 AM