quick SC300 O2 Sensor writeup
#31
Driver
iTrader: (1)
Is there any chance that it's not the right o2 sensor since I keep reading that there is a total of 3 sensors. Just replaced mines with a denso a couple minutes ago and I still have a the light throwing code 21? This is on a 95 sc300. Could it be a bad sensor or the other sensor pre cat? Thanks.
#32
Driver School Candidate
Join Date: Nov 2014
Location: ca
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Cde 25 and 26
Step 3)
Then remove the O2 sensor plug-in clip (a flathead works well, be careful, those things are brittle when old)
(speaking of clips, I needed to clip my nails there...)
Step 4)
Cut the wires off of the old O2 sensor solder/electrical tape/bubble gum that new universal Bosch sensor in.
Step 5)
Reinstall everything, reconnect the battery, enjoy life.
John[/QUOTE]
Then remove the O2 sensor plug-in clip (a flathead works well, be careful, those things are brittle when old)
(speaking of clips, I needed to clip my nails there...)
Step 4)
Cut the wires off of the old O2 sensor solder/electrical tape/bubble gum that new universal Bosch sensor in.
Step 5)
Reinstall everything, reconnect the battery, enjoy life.
John[/QUOTE]
Thread
Thread Starter
Forum
Replies
Last Post