1LS400 code 12&13
#1
Driver
Thread Starter
iTrader: (1)
Join Date: Dec 2008
Location: ok
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
1LS400 code 12&13
recently my car just started to act up. and it got worse. now...when ever i turn on my car id say about 15-20 mins of driving it would jsut shut off. has power but shuts off. i ran the CEL and it came up as 12 (RPM signal- no signal) and 13 (RPM signal open or short)
i just replaced the crank angle sensor or the crank position sensor. and it is still doing the same thing..
the weird thing is.. is that on cold start it would misfire untill it warms up a little and when i have it under load it would misfire at 3K+ RPM.
here are somethings i did to the car when i bought it
new water pump
new timing belt
new serpentine belt
new plugs/wires
I have not installed new Fuel filter or rotors.
i'm stumped at this and have been looking at the schematics and i guess tomorrow i'mma have to start from the Crank angle and work my way out from there.. any thoughts? or comments.... i tried searching and found a thing or two..but i want to make sure
one of the threads said something about not getting signal...
thanks...
i just replaced the crank angle sensor or the crank position sensor. and it is still doing the same thing..
the weird thing is.. is that on cold start it would misfire untill it warms up a little and when i have it under load it would misfire at 3K+ RPM.
here are somethings i did to the car when i bought it
new water pump
new timing belt
new serpentine belt
new plugs/wires
I have not installed new Fuel filter or rotors.
i'm stumped at this and have been looking at the schematics and i guess tomorrow i'mma have to start from the Crank angle and work my way out from there.. any thoughts? or comments.... i tried searching and found a thing or two..but i want to make sure
one of the threads said something about not getting signal...
thanks...
Thread
Thread Starter
Forum
Replies
Last Post
ki_soarer
Performance & Maintenance
16
08-02-11 12:21 PM