Bent Valance
#1
Driver
Thread Starter
Bent Valance
I didn't have much luck in another section of the website so figured I would check for feedback here. I have a bent valance from unknown origin although I don't recall backing into anything and it seems to be too low for another vehicle to cause this damage. Can these be easily bent back into shape as it's just a hard plastic or would I likely need to replace the part? The car was quite dirty at the time of the photo but the bend is near the left exhaust if not obvious.
Thread
Thread Starter
Forum
Replies
Last Post
emg2919
SC430 - 2nd Gen (2001-2010)
2
07-29-10 03:16 PM