NJ Inspection with AEM???
10-16-06, 02:56 PM
#1
Lead Lap
Thread Starter
NJ Inspection with AEM???
Anybody ever pass NJ inspection with an AEM EMS? If so, what shop did your inspection and are there any "tricks" to getting it through? I'm about to get ,y car back (after 5 months in the shop!!) and of course my inspection is due in December 
Any help/advice would be greatly appreciated!
-Mike
Any help/advice would be greatly appreciated!
-Mike
10-16-06, 08:34 PM
#3
Lead Lap
Thread Starter
10-17-06, 05:14 PM
#5
Lead Lap
Thread Starter
Hey Bro! Haven't had my car all summer so I couldn't bear to visit CL 
I'm still waiting for my tuner to finish up the turbo install. He's been working on it since June 3!!! What was supposed to be 3 weeks has turned into 4 1/2 months and counting!! I think he's just waiting on the I/C fabrication and then it's off to the dyno. At this rate, I'll be getting it back just when it's due for inspection (December!), hence the question about whether anybody in Jersey has managed to get through inpsection with an AEM installed. Still no replies
I'm still waiting for my tuner to finish up the turbo install. He's been working on it since June 3!!! What was supposed to be 3 weeks has turned into 4 1/2 months and counting!! I think he's just waiting on the I/C fabrication and then it's off to the dyno. At this rate, I'll be getting it back just when it's due for inspection (December!), hence the question about whether anybody in Jersey has managed to get through inpsection with an AEM installed. Still no replies
10-17-06, 05:18 PM
#6
Hey Bro! Haven't had my car all summer so I couldn't bear to visit CL
I'm still waiting for my tuner to finish up the turbo install. He's been working on it since June 3!!! What was supposed to be 3 weeks has turned into 4 1/2 months and counting!! I think he's just waiting on the I/C fabrication and then it's off to the dyno. At this rate, I'll be getting it back just when it's due for inspection (December!), hence the question about whether anybody in Jersey has managed to get through inpsection with an AEM installed. Still no replies
I'm still waiting for my tuner to finish up the turbo install. He's been working on it since June 3!!! What was supposed to be 3 weeks has turned into 4 1/2 months and counting!! I think he's just waiting on the I/C fabrication and then it's off to the dyno. At this rate, I'll be getting it back just when it's due for inspection (December!), hence the question about whether anybody in Jersey has managed to get through inpsection with an AEM installed. Still no replies
It's good to see you back! If you need help with your IC piping I can have it fabricated for you in a few hours. Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
Deegee
Performance & Maintenance
9
07-21-15 09:54 AM
