NX200t Hitch Receiver
#1
Driver School Candidate
Thread Starter
Join Date: May 2015
Location: Ohio
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
NX200t Hitch Receiver
I am trying to find a trailer hitch receiver assembly that will fit a nx200t. I would like to attach a bicycle rack to the hitch. I did not opt for the tow package and I am not sure what will fit the vehicle. Has anyone had any success installing one? I am open to other options such as a trunk gripper, but again I do not know what would fit this model and I would prefer the hitch. Thanks in advance!
#2
#3
if you decide on one of the aftermarket hitches please take a photo and share it here. A few of us are waiting to see how it looks and where it sits in relation to the bumper before buying. There are a couple of examples so far but more is always helpful.
#4
Driver School Candidate
Join Date: May 2015
Location: MD
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
For those going this route, please be advised that the fit along the mounting surfaces (between the left and right sides of the hitch) is exact to the vehicle frame. After installing one side with the bolts loosely tightened, I found that there was no wiggle room on the other side. I had to use a padded wrench to gain enough leverage to lift the hitch over the frame in order to align the holes and insert the remaining bolts. I was on my back on the garage floor when I installed the hitch, so that may have added to the minor difficulty i experienced. If one has access to a shop with a lift to elevate the vehicle, or maybe even using the mechanics/service ramps, both would be ideal ways to install the hitch.
I certainly preferred the OEM tow hitch for better aesthetics and a little more ground clearance, but I used the money towards the aftermarket clear protection film. Overall, I am satisfied with the hitch, and looking forward to mounting the bike rack when we head to our local trails.
Thread
Thread Starter
Forum
Replies
Last Post
winglesss
NX - 1st Gen (2015-2021)
1
04-13-18 07:00 AM