When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
ther is no preout for an amplifier ,the amplifier is in the HU Fujitusten ...
Please wait until this Friday, cause this Friday i will open again my car to install the Helix dsp or an AXMP 01 pioneer
it is easy with a multimeter to find the speaker , but if you can't wait this Friday i will post the way to get the signal from the level speaker
ther is no preout for an amplifier ,the amplifier is in the HU Fujitusten ...
Please wait until this Friday, cause this Friday i will open again my car to install the Helix dsp or an AXMP 01 pioneer
it is easy with a multimeter to find the speaker , but if you can't wait this Friday i will post the way to get the signal from the level speaker
With million thanks.
If you have a wiring diagram, it is prefect
Does it have a stock power amp at the back of nx?
U don't need a helix dsp if your not gonna change the speakers. Audison has a 2 ch loc with auto turn on. I took the signal from the rear sub. That's what I did in my nx.
U don't need a helix dsp if your not gonna change the speakers. Audison has a 2 ch loc with auto turn on. I took the signal from the rear sub. That's what I did in my nx.
HELIX DSP only permets to add delay and phase on the speakers with additional amplifiers.
The way you did with the Audison is a good solution ,but if it was for a full range speaker you will hear a lot of floornoise.This floornoise do not appears on the subwoofer channel
HELIX DSP only permets to add delay and phase on the speakers with additional amplifiers.
The way you did with the Audison is a good solution ,but if it was for a full range speaker you will hear a lot of floornoise.This floornoise do not appears on the subwoofer channel
I'm aware of that as I have a helix dsp pro in my 2013 gs350 f sport running full hertz Mille. Running active. All these guys wanted was jus a sub in there car so they don't need a dsp. I have zero floor noise in my nx.
HELIX DSP only permets to add delay and phase on the speakers with additional amplifiers.
The way you did with the Audison is a good solution ,but if it was for a full range speaker you will hear a lot of floornoise.This floornoise do not appears on the subwoofer channel
Good luck with your Iasca setup. I found the nx has a lot of rattles in the back
4 channels amp is fine for me.
Since I want to add a power amp to drive 8 speakers in NX
Alpine PDX fullrange class D are good amplifiers but only good amplifiers, not at the level of the class A or class a/b amps traditional
If the way is compactness and power i will prefer Audison or Kenwood
yes very strange
i think the only way is to take a multimeter to test in ohmeter mode the speakers or with a battery AA
Meanwhile you can take a look at the colors of the wire for each speaker
Finally, i open nx tonight and discover that a pioneer amp is at the back. Two wiring seems input and speaker out are found.
For the input wiring, how to identify the FL, FR, RL, RR?
Can I directly connect to the RCA jack then go into the aftermarket power amp?