gallico916

Mu assumption is another computer module for the 360 system and the correct firmware/software for that
@tundotcom thank you so much for testing this, appreciate the effort

tundotcom

So I saw this video on youtube. Obviously it can be done aftermarket.

tundotcom

Another factor to consider. The 360 equipped vehicles have a button next to the middle AC vents that allow you to access the system and change settings.

Electric65

Do you have a pic? The aftermarket video looks interesting… I think there was a Chinese aftermarket 360 cam add-on for the older NX 300 series

tundotcom

good video by @lsft

Electric65

Actually found the aftermarket 360 cam listing — appears to actually be compatible with the NX 350 series as well. Comes with the mirror cameras, extra wiring, CPU box, etc. and says that it’s plug and play. Fairly cheap price too, so definitely would be worth it assuming it works

https://www.alibaba.com/product-deta...472010031.html

gallico916

You can see this in this video. since its a right-side car, it will be under the right big ****

tundotcom

If anyone wanted to get the dashboard vent trim with the button, the part number is 55670F6010

but without taking it apart, there's no way to know if there's a cable inside the dash to connect it to.

https://parts.lexus.com/p/114921531/55670F6010.html

but again, probably still a waste of time and money without the proper software

tundotcom

So I impulse bought this on eBay... I'll get around to tearing down the center console and seeing if the appropriate cable is sitting back there.

Electric65

Keep us posted

I'm also curious if anyone here has tried one of the aftermarket 360 cam solutions that seem to integrate with the factory system? Like below:

https://www.alibaba.com/product-deta...472010031.html

Comes with the mirror cameras, extra wiring, CPU box, etc. and says that it’s plug and play.

tundotcom

The mission is a failure. There is no cable hidden away behind there.

Electric65

Damn. Worth trying at least. Does it look like any of the plugs from the aftermarket kit in the below photo would fit into the dash button I that trim piece?

tundotcom

Too hard to tell from that picture alone.

tundotcom

Actually, if this one on the top left was 7 pins, it would probably fit into the back of the trim piece.

Electric65

I bet you'll need that silver processor module shown in the aftermarket kit to make the factory system recognize the cameras and show the view