bolt pattern on 1UZ and R154 bellhousing (SC400 auto to 5speed project)
09-18-05, 12:49 PM
#160
Driver School Candidate
Join Date: Apr 2004
Location: Florida
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by VSsc400
i was told to pick up the car this coming wednesday. Seems like this time it will happen. Cross my fingers...
09-28-05, 08:45 AM
#162
okay tranny finally cleared and it's in.
clutch bites well
checking for crank play
hydraulic lines going in this week to next
i guess we are looking at middle of october for tranny swap to be done
3rd week of october for the exhaust
end of october for body kit
hopefully sooner... but we'll see...... This started in December 28 of 2004....... it's now been 9 months of waiting for it to come together..... I guess it will be full 10 months before I get to drive her....
clutch bites well
checking for crank play
hydraulic lines going in this week to next
i guess we are looking at middle of october for tranny swap to be done
3rd week of october for the exhaust
end of october for body kit
hopefully sooner... but we'll see...... This started in December 28 of 2004....... it's now been 9 months of waiting for it to come together..... I guess it will be full 10 months before I get to drive her....
Last edited by VSsc400; 09-28-05 at 10:31 PM.
10-10-05, 08:46 PM
#165
Originally Posted by VSsc400
bellhousing needed to be machined down 3mm..... everything but the headder is back off the car.
What? Make sure your shop can do this properly. A hand grinder isn't going to cut it. Find a specialized MACHINE shop.