mohdparts egr removal kit.
#16
Lexus Champion
Thread Starter
Join Date: Jul 2003
Location: Arizona
Posts: 1,623
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Originally Posted by 96sc3
how many lines does the egr have?,.., which lines are runnign to eachother and which are capped?
Lines that stay 3.. Just do it man just do it I promise you its pretty straight forward once you remove the egr vacum and egr valve itself.
its the 3 lines which run directly into the EGR modulator and egr valve itself. Coming underneath from the y shaped intake piece.
heres what I did with them..
#18
Lexus Champion
Thread Starter
Join Date: Jul 2003
Location: Arizona
Posts: 1,623
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
EGR Bottom block off plate, made from a spare egr gasket I used as a template. Notice the use of washers to compensate for lack of width for the steel sheet. While its certainly more then thick enough to do the job. Its not thick enough to use the stock bolts. In this case 3 washers for each screw was necessary. I still left the stock egr gaskets underneath to make sure it gets a good seal. No type of sealant is necessary.
In top block plate only one washer for each screw is needed.
In top block plate only one washer for each screw is needed.
#20
Driver School Candidate
Join Date: Oct 2007
Location: WA
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
EGR valves are an emissions control device for idle and part throttle driving, most cars shut it off once the car has come up to temp. All removing it does is make it harder for you to pass emissions, and give the tuner community a bad name when people outside it hear about us disabling emissions control devices.
Thread
Thread Starter
Forum
Replies
Last Post
sj408
Performance & Maintenance
3
03-18-10 09:02 PM