Engine stand - how did you do it?
#1
Lexus Test Driver
Thread Starter
iTrader: (2)
Join Date: Jul 2003
Location: California
Posts: 1,177
Likes: 0
Received 0 Likes
on
0 Posts
Engine stand - how did you do it?
I'd like to know how you guys mounted your engine on the engine stand.
If you could provide bolt sizes/pitches, would be even better.
Thanks,
~Alan
If you could provide bolt sizes/pitches, would be even better.
Thanks,
~Alan
#3
Lexus Test Driver
Thread Starter
iTrader: (2)
Join Date: Jul 2003
Location: California
Posts: 1,177
Likes: 0
Received 0 Likes
on
0 Posts
...no wait....one more...
Why didn't I think of the tranny bolts?
LOL!
I'm not too familiar with the design of engine stands, but how do you get the arms to line up with the holes in the bell-housing?
Thanks,
~Alan
Why didn't I think of the tranny bolts?
LOL!
I'm not too familiar with the design of engine stands, but how do you get the arms to line up with the holes in the bell-housing?
Thanks,
~Alan
#4
Originally Posted by SPORTcoupe
...no wait....one more...
Why didn't I think of the tranny bolts?
LOL!
I'm not too familiar with the design of engine stands, but how do you get the arms to line up with the holes in the bell-housing?
Thanks,
~Alan
Why didn't I think of the tranny bolts?
LOL!
I'm not too familiar with the design of engine stands, but how do you get the arms to line up with the holes in the bell-housing?
Thanks,
~Alan
#5
On most stands I have used, they bolt right up, but you may need to trim the actual sleeves the bolts go through on the stand. We trim them down to get more threads into the block.
Thread
Thread Starter
Forum
Replies
Last Post
FD3etty
Performance & Maintenance
2
01-19-15 03:47 PM
6SOARER
GS - 2nd Gen (1998-2005)
3
10-09-14 09:50 PM