When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Its going into a 93 sc300 factory 5sp. I am just trying to save myself the hassel of putting the trans in place 4-5 times to get the correct size. A write up with mesurments I can not find.
if you are using the swan neck, then i would extend it 2 3/4" if you are using a short throw then i would extend it 4 inches or so. I went from auto so i had to make a new cutout since the auto is in a different location.
Supraman24 if you are using the swan neck, then i would extend it 2 3/4" if you are using a short throw then i would extend it 4 inches or so. I went from auto so i had to make a new cutout since the auto is in a different location.
So if you extend it 4inches or so wouldn't that put it rite in the middle of the auto hole?