T67 turbo (NA-T): 8.5:1 or 9.0:1 compression?
#17
So you're boosting again! LOL! Can't stay away from boost, huh.
I was planning on using a supra tt head gasket along with other upgrades to reach my goal of 350rwhp+. I don't want to lower the compression too much but all of this won't happen anytime soon.
Anyway, good luck on your project Allen.
~Josh
I was planning on using a supra tt head gasket along with other upgrades to reach my goal of 350rwhp+. I don't want to lower the compression too much but all of this won't happen anytime soon.
Anyway, good luck on your project Allen.
~Josh
#18
So you're boosting again! LOL! Can't stay away from boost, huh.
I was planning on using a supra tt head gasket along with other upgrades to reach my goal of 350rwhp+. I don't want to lower the compression too much but all of this won't happen anytime soon.
Anyway, good luck on your project Allen.
~Josh
I was planning on using a supra tt head gasket along with other upgrades to reach my goal of 350rwhp+. I don't want to lower the compression too much but all of this won't happen anytime soon.
Anyway, good luck on your project Allen.
~Josh
I used a Cometic 2.5mm head gasket. It will lower the compression to about 8.4:1. I'm shooting for 500rwhp
Allen
Thread
Thread Starter
Forum
Replies
Last Post
15, 2jz, 2jzge, 851, advantages, compression, compressione, make, nat, psi, spool, t67, time, turbo, ur