Clutch Line Removal???
#1
Lead Lap
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: MD
Posts: 504
Likes: 0
Received 0 Likes
on
0 Posts
Clutch Line Removal???
Okay so here is the short/long issue and I need help so I can get this out asap. I am pulling my 2jz/w58 combo and I am damn near done and ran into a problem.
I removed the slave cylinder and know I need to pull off the bracket where the ground strap is connected and the clutch line is also attached. However, I cannot get any type of wrench/socket/etc in there to get it off and have been trying. Is there any suggestion/other way or do I just need to disconnect the line and then deal with bleeding it and such after I finish my 1j swap?
Thanks for the help
I removed the slave cylinder and know I need to pull off the bracket where the ground strap is connected and the clutch line is also attached. However, I cannot get any type of wrench/socket/etc in there to get it off and have been trying. Is there any suggestion/other way or do I just need to disconnect the line and then deal with bleeding it and such after I finish my 1j swap?
Thanks for the help
Thread
Thread Starter
Forum
Replies
Last Post
Ajchester
IS - 2nd Gen (2006-2013)
0
05-22-18 11:54 AM