ScottURnot

iTrader: (33)

I can see it now. Cool progress!

c0wboy

Why were the holes cut into the driver and passenger trays? They look new. Is piping going to run through there?

Eric

LCSC

iTrader: (4)

Lookin good can't wait to see it in action

shern

iTrader: (6)

Wow, everything looks great!

I need to learn how to weld

setsuna57

hey lextreme have you looked into the 5.7 short blocks yet....I'd love to have an sc570 all motor monster...and its awesome what your doing with your cars you give me hope lol

white07

amazing......

Lextreme

Got some updates your CL members. Picked up my transmission/cross member adaptor plate. Here is a picture.

Lextreme

I just picked up this custom driveshaft. Front Chevy TH400 and rear is Lexus.

ScottURnot

iTrader: (33)

nice updates!

Lextreme

I would love to, but the price for this engine will very expensive. A complete roll over 5.7L Tundra is around $15,000 USD. That was few months back, but I am sure they are cheaper now. I started this 4.7L before the 5.7L were sold.

Thanks Scott,

Slowly but surely..... Taking the engine out this week for down pipes.

Lextreme

Anyway, I have some updates. Got my 4" elbow long legs (10"). They are very hard to find and expensive too. Got them and cut them down to fit the turbo inlet. Getting fresh air from outside. The goal is to get cold air and keep them cold. Notice the pipe routings are kept away from heat source. Here are some pictures

Lextreme

Here is another picture of the driver side.

Lextreme

Here is a general picture of the two inlet elbows.

kyoso23

Good Lord.

parnzen

u my friend are amazing