installation kit for walbro fuel pump gss341
#2
Lead Lap
iTrader: (1)
yes use the original wires, your old plug might plug in, if it doesnt then use the supplied adapter "plug" that came with your pump, match the color of the wires splice solder and tape.
there is a whole write up on www.clubna-t.com or here, search is your friend.
there is a whole write up on www.clubna-t.com or here, search is your friend.
#3
yes use the original wires, your old plug might plug in, if it doesnt then use the supplied adapter "plug" that came with your pump, match the color of the wires splice solder and tape.
there is a whole write up on www.clubna-t.com or here, search is your friend.
there is a whole write up on www.clubna-t.com or here, search is your friend.
#4
Lead Lap
iTrader: (1)
actually i am sorry dont use electric tape, your right the fumes will actually make the tape not stick anymore, and if you want to use heatshrink make sure you use a heat gun or something similar, i would suggest using a lighter near gas fumes.
I used the small electric plastic twist ons, i dont know what you call them, but basically what electricians use in electric conduits etc. I would believe that is your safest bet. good luck
I used the small electric plastic twist ons, i dont know what you call them, but basically what electricians use in electric conduits etc. I would believe that is your safest bet. good luck
Thread
Thread Starter
Forum
Replies
Last Post
onebadshot
Performance & Maintenance
4
06-26-06 08:01 PM