E-manage ultimate and map sensor
#1
Pole Position
Thread Starter
iTrader: (1)
Join Date: Jun 2007
Location: nh
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
E-manage ultimate and map sensor
I am having problems. with my car ...not me
2jz-gte in a sc400
phoenix tuning did the harness and that works fine. when i cut the pressure sensor and tap in the e manage it says the input voltage is right but it wont output the right voltage. spliced back to stock then it runs better. any ideas?
2jz-gte in a sc400
phoenix tuning did the harness and that works fine. when i cut the pressure sensor and tap in the e manage it says the input voltage is right but it wont output the right voltage. spliced back to stock then it runs better. any ideas?
#2
1UZFE/2JZGTE
iTrader: (11)
I'm not familiar with e-manage but shouldn't there an option to adjust the output voltage. Basically the stock ecu must be fooled into only thinking that a certain voltage is coming in. So since the e-manage is in between the actual signal and what's going to the ECU it should be able to tell the ECU the "right" voltage.
Last edited by plex; 01-28-08 at 04:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post
dubseven
Performance & Maintenance
4
04-09-15 10:47 AM