Trying To Remove A R154
#1
Trying To Remove A R154
What gear does the tranny need to be in to get it to separate from the engine block. I have all the bolts off and a one inch gap(between the block and the bellhousing) just can not get it to separate.
#3
you need to remove the inspection plates on the bell housing. From there unbolt the pressure plate through the inspection plate holes, since it is semi-attached to the throw-out fork. from there take it to the gun-show and shake it loose.
Thread
Thread Starter
Forum
Replies
Last Post
turbocorey
Performance & Maintenance
2
08-21-08 10:43 PM