ClubLexus - Lexus Forum Discussion

Performance & Maintenance Engine, forced induction, intakes, exhausts, torque converters, transmissions, etc.

1992 sc300 1jz & r154 swap

Thread Tools
 
Search this Thread
 
Old 06-07-08, 08:17 PM
  #76  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default
i also bolted up the sc300 manual brake pedal, and drilled the clutch pedal assembly holes.1992 sc300 1jz & r154 swap-picture-371.jpg
gdc5ind is offline  
Reply Like
Old 06-07-08, 08:21 PM
  #77  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default
here is a new issue. i was going to try and use the soarer clutch master cylinder but it hits1992 sc300 1jz & r154 swap-picture-368.jpg
Last edited by gdc5ind; 06-08-08 at 12:29 AM.
gdc5ind is offline  
Reply Like
Old 06-08-08, 08:25 AM
  #78  
trppen37
Driver School Candidate
 
trppen37's Avatar
 
Join Date: May 2008
Location: CA
Posts: 11
Likes: 0
Received 0 Likes on 0 Posts
Default
keep up the good work! dunno what to say about the soarer clutch master cylinder..
trppen37 is offline  
Reply Like
Old 06-09-08, 07:02 PM
  #79  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default update
i just ordered 97 twin turbo motor mounts from carson toyota, he said they will be in Wednesday. i also spoke with dave at driftmotion and he has my 1jz overhaul gasket set and my clutch master cylinder, to fix my problems.
Last edited by gdc5ind; 06-09-08 at 09:53 PM.
gdc5ind is offline  
Reply Like
Old 06-09-08, 07:52 PM
  #80  
rawdil49
Pole Position

 
rawdil49's Avatar
 
Join Date: Jan 2008
Location: il
Posts: 239
Likes: 0
Received 0 Likes on 0 Posts
Default
bpu stands for basic power upgrade. it is universal for any motor.
rawdil49 is offline  
Reply Like
Old 06-09-08, 08:20 PM
  #81  
Turbo?
Pole Position
 
Turbo?'s Avatar
 
Join Date: Feb 2008
Location: Ontario
Posts: 329
Likes: 0
Received 0 Likes on 0 Posts
Default
what company did you get the front clip???
Turbo? is offline  
Reply Like
Old 06-09-08, 08:40 PM
  #82  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default
this is where i bought it fromhttp://www.jrautoparts.com/toyota_clip1.htm
gdc5ind is offline  
Reply Like
Old 06-11-08, 06:46 AM
  #83  
AdamLexus
Pole Position

iTrader: (1)
 
AdamLexus's Avatar
 
Join Date: Nov 2005
Location: CA
Posts: 230
Likes: 0
Received 0 Likes on 0 Posts
Default
Nice job so far. I can't wait to get my project started here in the next couple of weeks.
AdamLexus is offline  
Reply Like
Old 06-11-08, 03:17 PM
  #84  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default
update:
i picked up my new 1997 supra tt motor mounts(insulator assembly lol) part number 12360-46111 $152 1992 sc300 1jz & r154 swap-picture-372.jpg
gdc5ind is offline  
Reply Like
Old 06-11-08, 05:37 PM
  #85  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default
i want to try and get the most out of the stock twin turbos, if i bought a map-ecu2 would it run my stock twin nicely and later when i upgrade to a single would the map ecu support 500hp around 20-25 psi? or should i just go with piggybacks like electronic boost controller, fuel cut defender, and speed cut controller?
Last edited by gdc5ind; 06-12-08 at 02:24 PM.
gdc5ind is offline  
Reply Like
Old 06-12-08, 10:48 AM
  #86  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default
what do you guys think about megan racing exhaust 3" inlet 4.50 out? i just want duel exhaust with little back pressure for cheap. i have spent to much money on this car in the last 2-3weeks. i should have never bought a entire clip it is a waste of money. you cant use most of the parts....
gdc5ind is offline  
Reply Like
Old 06-12-08, 04:09 PM
  #87  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default Knock Sensor
are these the knock sensor wires???1992 sc300 1jz & r154 swap-picture-373.jpg
gdc5ind is offline  
Reply Like
Old 06-12-08, 04:12 PM
  #88  
shern
Lexus Champion
iTrader: (6)
 
shern's Avatar
 
Join Date: Oct 2006
Location: AZ
Posts: 2,468
Likes: 0
Received 2 Likes on 2 Posts
Default
Originally Posted by gdc5ind
what do you guys think about megan racing exhaust 3" inlet 4.50 out? i just want duel exhaust with little back pressure for cheap. i have spent to much money on this car in the last 2-3weeks. i should have never bought a entire clip it is a waste of money. you cant use most of the parts....
Find a local exhaust shop that can fab up exhaust systems from scratch. Pick up a couple of Magnaflows and let them work their magic. Cheap and one of the best sounding systems you can run.
shern is offline  
Reply Like
Old 06-13-08, 04:47 PM
  #89  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default new parts
i picked up some parts from driftmotion today.
1.sc300/400 manual clutch master cylinder Part#31410-14310 115$
2.toyota oil filter part#90915-yzzd1 6$ea.
3.NGK iridium plugs Part#bcpr6eix-5689 8$ea.
4.overhaul gasket set Part#04111-46033 169$1992 sc300 1jz & r154 swap-picture-376.jpg
gdc5ind is offline  
Reply Like
Old 06-13-08, 10:49 PM
  #90  
gdc5ind
Pole Position
Thread Starter
 
gdc5ind's Avatar
 
Join Date: Jul 2007
Location: CA
Posts: 247
Likes: 0
Received 0 Likes on 0 Posts
Default
changed valve cover gasket and made her a little more sexy. finally looks like a 1jz now.:1992 sc300 1jz & r154 swap-picture-380.jpg
Last edited by gdc5ind; 06-13-08 at 10:52 PM.
gdc5ind is offline  
Reply Like



Advanced Search
Quick Reply: 1992 sc300 1jz & r154 swap


Reply Closed Thread Share
Forum Jump

All times are GMT -7. The time now is 12:29 PM.