LEXXIUM

iTrader: (1)

Are you still around I have a few questions as far as aligning trany with the 1uz, just got my first piece of the puzzle (1uz belhousing) and moving on to buying the trany. I've been doing some researching on v-eight.com, but don't know what pilot bearing to use for r154>1uz. Also with a trans adapter does it perfectly line up with pilot bearing hole?

Thanks

Sorry guys I had to bump this thread

Hil

iTrader: (61)

He sold his car

jadu

iTrader: (42)

^^ bummer i wanted to see it all finished

xxtoobsxx

iTrader: (4)

I think I picked up his car...I knew i recognized the nardi wheel. Its not complete though. Maybe ill finish what he started!

kolessc400

http://www.thor-racing.co.uk/R154_to...41UZFE_KIT.asp
check this websight out it has the adapter kit for adapting the r154 to the 1uz

sc4hunnit

Has anyone deciphered what driveshaft to use? I have a 95 auto and i want to see what i all need before i get started ordering stuff!

oscarcst

does anybody know how much it will cost just on parts to do this kind of swap

Nqyrnminds

Do you know what vehicle the flywheel is out of that is needed for the sc400 tranny swap? I'm not sure if that makes sense but I'm looking for details on the clutch set up for the swap.

stheodore

It's always so disappointing to read one of these older threads and never see the update from the OP that the project was ever finished. I hope it was, but I cannot imagine he wouldn't update the thread to show the finished project.