SC400 turns over but wont start
10-17-10, 10:15 AM
#16
Driver
Thread Starter
Join Date: Oct 2010
Location: mi
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Think i just figured out what happend..... When i was taking off the the crankshaft pulley the timing belt was not on..... so depending on if my engine is interface or not i would have bent the valves. Are the 92 sc400's interface or non?
Last edited by 1uzfe4147; 10-17-10 at 10:57 AM.
10-17-10, 11:57 AM
#17
Driver
Thread Starter
Join Date: Oct 2010
Location: mi
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Nvm the 92's are non interface so the valves are not bent. I 10x checked the timing belt so i don't see how that's off? Let me go take a picture of the marks and ill post
Oh and i had someone start for me and it backfired through the air intake, whats that mean?
Seems like the LH cam pulley is off by one notch. I am going adjust it and check, be back in a bit with an update
Oh and i had someone start for me and it backfired through the air intake, whats that mean?
Seems like the LH cam pulley is off by one notch. I am going adjust it and check, be back in a bit with an update
Last edited by 1uzfe4147; 10-17-10 at 01:13 PM.
10-17-10, 07:35 PM
#19
Driver
Thread Starter
Join Date: Oct 2010
Location: mi
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Dont say that lol! I am depending on this being what is screwed up.
Thread
Thread Starter
Forum
Replies
Last Post
BlacBeaute
ES - 1st to 4th Gen (1990-2006)
4
11-28-11 11:18 PM
MauiGS300
GS - 2nd Gen (1998-2005)
11
06-13-09 05:43 PM
