Doing some work on my 2JZ-GTE SC400
10-03-11, 05:03 PM
#16
Ok guys so ordering all the wire for the extension to move the fuse box to the trunk. for the fuse box I am ordering 200' of #14 AWG stranded, 30' #6 AWG stranded, 80' #8 AWG stranded wire for the extension harness. I will be shrink wrapping all the wire and running it through the cab VS under the car. I am still looking for the route to run the wire tho. I will be installing a 24 pin connector in the trunk for all the #14 AWG and a 3 and 10 wire connector for the other wires. I will be extending the power steering lines to the back fire wall, and that should free up ll the space for the new intake manifold and the new billet TB. I am going to be re wrapping the entire harness while I am at this and trying a wire tuck but not sure how it is going to turn out lol. Lets hope for the best.
10-14-11, 09:00 AM
#17
ok cleaned up a bit valve covers polished and rust problem is getting under control. Got my new TMS cam gears, TMS damper, PWR timing belt, billet tensioner all in the mail on it's way to me now. I just cut down the fuse box and got the wiring al cleaned up but wont be posting those pics till tonight.
10-15-11, 06:19 PM
#19
Thanks been working non stop on it lately. Hey Greg news was going to swap trans out with new boost logic and 3800 stall. I was also going to use supra stick. Well turns out car already has all these parts. Don't laugh at me last owner knew nothing and I have had it for 3 weeks never seen it run lol.
10-22-11, 02:33 PM
#20
Hey guys well been hard at work well kinda lol. Here are a few pics from today I just took o some stuff
Well to start fuse box is in the back seat now due to intake manifold
So now I am splicing and running all the wires to get it there spliced all the engine bay wires so far and ran 2 wires to the fuse box so getting there. I will be caving up a aluminum fuse box to replace the plastic one. I will be placing the fuse box in the center of where the back seat was located. But here are a few pics.
Also here are some pics of the calipers. Sanded with 220,800,1500 grit sand paper and Painted blk and clear coated.
Well to start fuse box is in the back seat now due to intake manifold
So now I am splicing and running all the wires to get it there spliced all the engine bay wires so far and ran 2 wires to the fuse box so getting there. I will be caving up a aluminum fuse box to replace the plastic one. I will be placing the fuse box in the center of where the back seat was located. But here are a few pics.
Also here are some pics of the calipers. Sanded with 220,800,1500 grit sand paper and Painted blk and clear coated.
Thread
Thread Starter
Forum
Replies
Last Post
Weapon F
IS F (2008-2014)
3
03-31-18 06:51 PM
