Help! Gas/Fuel in Throttle Body
#17
I have a stock 1993 SC300 that I have lost two engines with bent rods...First one I found the number two and three cylinders full of fuel and in the the intake runner...Second engine I drove it 78 miles before it died and discovered that this time the number six cylinder and intake runner was full of fuel...What is causing this problem? I'm suspecting an ECU? I did the 12 volt conversion after I lost the first motor.
#18
audi121 -
I am going to use Foreign Auto Computer
They have been repairing ECUs for the DSM crowd for over 10 years. I've seen some for a little cheaper on ebay but these people have built a reputation for quality work. I have never seen a post by anyone dissatisfied with their results.
I am going to use Foreign Auto Computer
They have been repairing ECUs for the DSM crowd for over 10 years. I've seen some for a little cheaper on ebay but these people have built a reputation for quality work. I have never seen a post by anyone dissatisfied with their results.
#20
Pole Position
iTrader: (2)
Join Date: Jul 2009
Location: MN
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
I have a stock 1993 SC300 that I have lost two engines with bent rods...First one I found the number two and three cylinders full of fuel and in the the intake runner...Second engine I drove it 78 miles before it died and discovered that this time the number six cylinder and intake runner was full of fuel...What is causing this problem? I'm suspecting an ECU? I did the 12 volt conversion after I lost the first motor.
#21
Driver School Candidate
Thread Starter
Join Date: May 2010
Location: MD
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
audi121 -
I am going to use Foreign Auto Computer
They have been repairing ECUs for the DSM crowd for over 10 years. I've seen some for a little cheaper on ebay but these people have built a reputation for quality work. I have never seen a post by anyone dissatisfied with their results.
I am going to use Foreign Auto Computer
They have been repairing ECUs for the DSM crowd for over 10 years. I've seen some for a little cheaper on ebay but these people have built a reputation for quality work. I have never seen a post by anyone dissatisfied with their results.
Thread
Thread Starter
Forum
Replies
Last Post
supafreeza
ES - 1st to 4th Gen (1990-2006)
4
09-30-09 11:19 AM