JDM 2JZGTE VVTi wont start
#1
Driver School Candidate
Thread Starter
Join Date: Jan 2016
Location: Texas
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
JDM 2JZGTE VVTi wont start
Hello,
I'm trying to start an Aristo 2jz on the engine stand but i dont seem to be getting spark. The etcs-i is working, but there is no voltage between B+ and ground on the plug for the d61 igniter.
I have the pins in red connected to positive and the one in blue to ground. also have walbro 485 hooked up for fuel in a bucket.
I'm trying to start an Aristo 2jz on the engine stand but i dont seem to be getting spark. The etcs-i is working, but there is no voltage between B+ and ground on the plug for the d61 igniter.
I have the pins in red connected to positive and the one in blue to ground. also have walbro 485 hooked up for fuel in a bucket.
#7
Super Moderator
iTrader: (34)
it should be ...but just trying to make sure since it wasn't mentioned what wiring you used or how the engine was wired . I was thinking you rigged your own since you said the ETCS-i is working ... I don't see the +BM pin wired which provides power to the eletronic throttle system which sends signals to the ECU.
Thread
Thread Starter
Forum
Replies
Last Post
suprakidxx
Performance & Maintenance
2
03-27-17 03:23 AM