What components run off EFI Fuse?
#16
Update,
Raised the car up on all four jacks, let it run for about 15 minutes so it was nice a hot. Bumped around the exhaust and o2 sensors and couldn't replicate the problem.
Next thing I tried was removing the EFI Relay in the engine bay fuse box as recommended by this thread here;
https://www.justanswer.com/lexus/31c...-back-car.html
Car wouldn't start at all and fuse did NOT blow. Put the relay back in and the car started up just fine.
Raised the car up on all four jacks, let it run for about 15 minutes so it was nice a hot. Bumped around the exhaust and o2 sensors and couldn't replicate the problem.
Next thing I tried was removing the EFI Relay in the engine bay fuse box as recommended by this thread here;
https://www.justanswer.com/lexus/31c...-back-car.html
Car wouldn't start at all and fuse did NOT blow. Put the relay back in and the car started up just fine.
#17
I had the same issue, EFI 2 7.5 amp fuse when I go up hill it blows and my MAF doesn't work and it goes into limp mode and car stalled
I thought it was my O2 sensor downstream, possibly a wire shorting due to spacer install in tight spot.
I removed spacer and put silicone around wire entry on O2 sensor and so far no more stalls or fuse blowing.
I have not fully tested this but just went to spots the fuse blew before trying to replicate and it didnt.
I thought it was my O2 sensor downstream, possibly a wire shorting due to spacer install in tight spot.
I removed spacer and put silicone around wire entry on O2 sensor and so far no more stalls or fuse blowing.
I have not fully tested this but just went to spots the fuse blew before trying to replicate and it didnt.
Thread
Thread Starter
Forum
Replies
Last Post