cluster issues.
#1
Driver School Candidate
Thread Starter
cluster issues.
I have a 1996 sc300
the light for the hand on my speedometer hasn’t worked since i got the car a few months ago while the rest light up red as usual. is there any way to fix the problem myself
the light for the hand on my speedometer hasn’t worked since i got the car a few months ago while the rest light up red as usual. is there any way to fix the problem myself
#2
Lead Lap
iTrader: (8)
If you find a good donor, you can replace the needles yourself. They just pop on and off the gauges. (Be careful to not get finger prints anywhere with the lens cover removed, or they'll drive you nuts later.) Tanin and others can also service them for you and/or send you replacement needles. If you're good with electronics and soldering, there also some write-ups on rebuilding the LED strip yourself.
The following users liked this post:
saucysc300 (01-31-21)
#3
Driver School Candidate
Thread Starter
If you find a good donor, you can replace the needles yourself. They just pop on and off the gauges. (Be careful to not get finger prints anywhere with the lens cover removed, or they'll drive you nuts later.) Tanin and others can also service them for you and/or send you replacement needles. If you're good with electronics and soldering, there also some write-ups on rebuilding the LED strip yourself.
#4
Here at TAE we offer replacement needle boards that are an easy DIY install and there is a how to video on the listing. You can also get our DIY LED backlight kit. PM us if you have any questions.
https://www.taninautoelectronix.com/...needle-boards/
https://www.taninautoelectronix.com/...needle-boards/
__________________
TANIN AUTO ELECTRONIX
262-456-4147
contact@taninauto.com
www.taninautoelectronix.com
TANIN AUTO ELECTRONIX
262-456-4147
contact@taninauto.com
www.taninautoelectronix.com
The following 2 users liked this post by TaninAuto:
KahnBB6 (01-31-21),
saucysc300 (01-31-21)
Thread
Thread Starter
Forum
Replies
Last Post