GILLEXUS

iTrader: (14)

Jeff so guys don't get mixed up the color coded plugs are viewing thm from the ends not the top in other words the numbers are reversed on the actual ECU - correct?

criminalR1

iTrader: (3)

all I want for Christmas is a GS400 pinout...........

aka paco

iTrader: (15)

Thanks man, hoping to tackle a GTE swap in a 02 SD soon..

GILLEXUS

iTrader: (14)

here ya go 2 of them

gregmessic

A mechanic told me that my ECU is going out... Do you know if I install a used ECU does it need to be reprogrammed?

GILLEXUS

iTrader: (14)

I'm not sure, I thought you needed to reprogram your master key unless it is a defferent ECU for that.

criminalR1

iTrader: (3)

it will need to be reprogramed if you dont have a matching key.(call around to you local lcksmith if you go this rout much much cheaper than dealer) ..if it comes with the matching key all u have to do is swap over the chip to your existing key and wall..A....(otherwise it will not disable the immobilizer and start if the key and ecu are not paired)......

jacksonvp

Do you have a VVTi GTE JDM pinout?

LexCafe

I' in the process of wiring the fi/c. The ecu pinouts that Jeff posted are positive (+) right? So all of the positive wires from the fi/c would connect to those but where do you connect the negative wires from the fi/c? (crk-, cam-, inj-, ect...) Please help.

qphoton

For GS2 '98-00 with 2JZ-GE VVT-i you can use IS300 '01 pinout:
01pinout.xls
where


Also for GS2 '01+ you can check IS300 '02+ pinout (don't sure):
02+IS300_ECU_Pinout.xls

qphoton

Full Lexus GS300 '98-05 Wiring manual you can download here
Lexus GS300 1997 - Wiring.zip

just enter code shown below.
onn the next page you need uncheck checkbox and click on the link above, download will start

LexCafe

Thanks. I had a brain fart few days ago but had it figured out. Had the fi/c hooked up and running. Now it just a matter of tunning to make it run right.

gijohnnyb

You are a God-send!

nezlyfe

thanks needed this for an o2 sim

Rande

love the pin out. question would be is do you or anyone know when i can get the wiring lay out for the jap spec aristo harness