Installing Takeda Intake on is250
#6
that vacuum tube is very loose for mine too and i thought it was going to fall off but once the cover was back on i suppose it added some pressure onto it. i haven't had it come off during operation at all.
Trending Topics
#10
Pole Position
so you installed the takeda specifically? because after installing mine i needed a stronger clamp since the factory one is no where tight enough to hold it. Either get a new tube or a new clamp.. one or the other.
#15
you need to disconnect your battery for 1-2mins and then reconnect it. make sure you just do the negative side.
i think the reason for this is the sensor in the intake gets the wrong readings. autozone looked up the error codes and it talked about O2 stuff.
once i put the batter back on all the warning lights turned off.
remember disconnecting your battery resets a lot of the electronics in your car to include your preset radio stations to your power windows (you wont be able to control them from the drivers seat). to fix this you need to go to each window and hold down the switch till its all the way down, then hold it up til its all the way up. weird, i know. but it works.
good luck
i think the reason for this is the sensor in the intake gets the wrong readings. autozone looked up the error codes and it talked about O2 stuff.
once i put the batter back on all the warning lights turned off.
remember disconnecting your battery resets a lot of the electronics in your car to include your preset radio stations to your power windows (you wont be able to control them from the drivers seat). to fix this you need to go to each window and hold down the switch till its all the way down, then hold it up til its all the way up. weird, i know. but it works.
good luck