09' IS350 Dyno before/after Joe Z intake/True Dual exhaust install
#1
Lead Lap
Thread Starter
Join Date: Sep 2002
Location: NC
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
09' IS350 Dyno before/after Joe Z intake/True Dual exhaust install
Well,
Like I had mentioned in my previous thread, I have ordered and am awaiting the arrival of my Joe Z intake, Joe Z Racing dual exhaust, and F-Sport filter.
I wanted to do a before and after dyno to get an good idea on the exact hp gains from the mods.
Went to the dyno this morning for some stock baselines and did 3 back to back pulls. I am pleasantly surprised at the stock hp numbers, as I thought they would be lower.
After I install the mods, I will return to the dyno and post the after charts and video.
Like I had mentioned in my previous thread, I have ordered and am awaiting the arrival of my Joe Z intake, Joe Z Racing dual exhaust, and F-Sport filter.
I wanted to do a before and after dyno to get an good idea on the exact hp gains from the mods.
Went to the dyno this morning for some stock baselines and did 3 back to back pulls. I am pleasantly surprised at the stock hp numbers, as I thought they would be lower.
After I install the mods, I will return to the dyno and post the after charts and video.
#2
Lead Lap
Thread Starter
Join Date: Sep 2002
Location: NC
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
Dyno sheet from 100% stock pulls.
UPDATE:
Dyno Sheet from after JoeZ Intake/F-Sport Filter/JoeZ Racing Exhaust
So you are probably thinking, only 10rwhp gain? 281hp PEAK. I made a spreadsheet from the data from each dyno pull. My power curve was moved lower with a total gain of 18.48RWHP @ 6000rpm, and 21.98ft/lbs torque @ 4200rpm. This is a VERY GOOD gain, and I am very happy with the results. Below is the spreadsheet.
UPDATED:
Dyno Video 100% stock vs JoeZ Intake/F-Sport Filter/JoeZ Racing Exhaust
Updated 11/10/12:
Launch video comparison between stock and mods:
F-sport filter
Joe Z Intake unboxed:
Joe Z Intake installed on car:
UPDATE: 10/29
Received the JoeZ Racing exhaust today (10/29/12) and am having it installed tomorrow morning.
UPDATE:
Dyno Sheet from after JoeZ Intake/F-Sport Filter/JoeZ Racing Exhaust
So you are probably thinking, only 10rwhp gain? 281hp PEAK. I made a spreadsheet from the data from each dyno pull. My power curve was moved lower with a total gain of 18.48RWHP @ 6000rpm, and 21.98ft/lbs torque @ 4200rpm. This is a VERY GOOD gain, and I am very happy with the results. Below is the spreadsheet.
UPDATED:
Dyno Video 100% stock vs JoeZ Intake/F-Sport Filter/JoeZ Racing Exhaust
Updated 11/10/12:
Launch video comparison between stock and mods:
F-sport filter
Joe Z Intake unboxed:
Joe Z Intake installed on car:
UPDATE: 10/29
Received the JoeZ Racing exhaust today (10/29/12) and am having it installed tomorrow morning.
Last edited by Lil4cyl; 11-10-12 at 03:42 PM.
#4
Lead Lap
Thread Starter
Join Date: Sep 2002
Location: NC
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
#6
Lead Lap
Thread Starter
Join Date: Sep 2002
Location: NC
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
Well, I went to my local 1/8th mile this evening. Last time I ran I was completely stock, and my best was 8.79@80.3mph.
This time I have the Joe Z intake, and f-sport filter installed. My best et today was 8.67@81.5mph.
What is odd is that was my lowest mph of the day. My best mph today was on an 8.69@83.9mph run. And all my other runs averaged 83+mph, which I attribute to the new mods
Was having bad problems with wheelspin.. averaging 2.0's 60fts. Really want to work my way down to high 1.8's or low 1.9's. I ended up lowering my air pressure on my Continental DWS's to 27psi... still having wheelspin. Tried off idle launch, and mostly did around 1000-1100rpm launches. Just wasn't hooking today. With a good 60ft, I think 8.5's would be possible.
now to see how the Joe Z exhaust helps out when I receive it. Should bump my 1/8th mph up in the 87-88mph range I would think, which isn't bad. May have to end up getting a set of drag radials to get the 60ft's where I want them.
This time I have the Joe Z intake, and f-sport filter installed. My best et today was 8.67@81.5mph.
What is odd is that was my lowest mph of the day. My best mph today was on an 8.69@83.9mph run. And all my other runs averaged 83+mph, which I attribute to the new mods
Was having bad problems with wheelspin.. averaging 2.0's 60fts. Really want to work my way down to high 1.8's or low 1.9's. I ended up lowering my air pressure on my Continental DWS's to 27psi... still having wheelspin. Tried off idle launch, and mostly did around 1000-1100rpm launches. Just wasn't hooking today. With a good 60ft, I think 8.5's would be possible.
now to see how the Joe Z exhaust helps out when I receive it. Should bump my 1/8th mph up in the 87-88mph range I would think, which isn't bad. May have to end up getting a set of drag radials to get the 60ft's where I want them.
Trending Topics
#8
Lead Lap
Thread Starter
Join Date: Sep 2002
Location: NC
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, they are a high treadwear tire. They are actually due to be changed and i am considering finding a set of rear rims and mounting et streets or drag radials on them for the track. Will definitely go with a stickier street tire on current rims though. I am also considering going ahead with the PPE headers and playing with a 65 shot of NOS.
#10
Lead Lap
Thread Starter
Join Date: Sep 2002
Location: NC
Posts: 407
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Hoovey...I had those same questions when I was looking to do mods and didnt see the info i needed..so I figured I might as well put it all in one post, so people interested in theJoeZ products can see hard numbers along with dragstrip mph gains.When I receive and install the JoeZ exhaust I will redyno the car to see the gains.
Last edited by Lil4cyl; 10-12-12 at 03:31 PM.
#13
Driver School Candidate
Join Date: Jan 2012
Location: va
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
yes... please keep an update on how the nitrous goes. Ive been throwing the idea up for about a month now about putting a small shot on my IS350. Ive had a few cars in the past ( k series Hondas) with nitrous but theres not very much info on how it works on the 350.
#14
IIRC HKS350 (or maybe it was someone else?) ran a nitrous setup on his IS350 and ran low 12s all day in the 1/4 mile. I don't recall his dyno #s right now.