What Have You Done To Your RC F Today?
#496
Ordered the TRD start button for ~$90.00.
The following users liked this post:
BossMoss (05-11-19)
#497
#500
Coming from Australia. This is the one with the light which I preferred. Model MS422-00001 (which has been discontinued). The one without the light for gas engines I believe is MS422-00003
https://www.ebay.com/itm/TRD-PUSH-ST...53.m2749.l2649
Looks like there's one left.
https://www.ebay.com/itm/TRD-PUSH-ST...53.m2749.l2649
Looks like there's one left.
Last edited by sensai; 05-12-19 at 09:24 AM.
The following users liked this post:
BossMoss (05-12-19)
#501
Time for Spark replacement. Upgrade
Haven't seen this posted on RCF board. Don't recall where I first saw them, think it was buried in some obscure ISF post.
Claimed to have the worlds smallest center electrode tip. Will report back my butt dyno results after install.
Claimed to have the worlds smallest center electrode tip. Will report back my butt dyno results after install.
The following 2 users liked this post by yellow2112:
BossMoss (05-14-19),
konichiwa3 (05-14-19)
#504
#505
Nengun sells them. Web link below last pic.
https://www.nengun.com/greddy/neodymium-magdrain
Last edited by konichiwa3; 05-14-19 at 11:50 PM.
The following users liked this post:
BossMoss (05-15-19)
#506
Pit Crew
iTrader: (2)
Is this what you are looking for?
Nengun sells them. Web link below last pic.
https://www.nengun.com/greddy/neodymium-magdrain
Nengun sells them. Web link below last pic.
https://www.nengun.com/greddy/neodymium-magdrain
FYI all, our drain plug is M12x1.25 if you're ordering one.
The following users liked this post:
BossMoss (05-15-19)
#507
Just dropped it off to get it detailed, clay, ceramic pro, paint correction and then top it off with xpel full front coverage including headlights and side views.
This will be by far the most I've ever paid to take care of the paint on a vehicle. Excited to see the outcome.
Full front:
And I need to stay off this site. I've just discovered AIMGAIN products.
This will be by far the most I've ever paid to take care of the paint on a vehicle. Excited to see the outcome.
Full front:
And I need to stay off this site. I've just discovered AIMGAIN products.
Last edited by sensai; 05-15-19 at 11:52 AM.
#508
Just dropped it off to get it detailed, clay, ceramic pro, paint correction and then top it off with xpel full front coverage including headlights and side views.
This will be by far the most I've ever paid to take care of the paint on a vehicle. Excited to see the outcome.
Full front:
And I need to stay off this site. I've just discovered AIMGAIN products.
This will be by far the most I've ever paid to take care of the paint on a vehicle. Excited to see the outcome.
Full front:
And I need to stay off this site. I've just discovered AIMGAIN products.
#509
Intermediate
Is this what you are looking for?
Nengun sells them. Web link below last pic.
https://www.nengun.com/greddy/neodymium-magdrain
Nengun sells them. Web link below last pic.
https://www.nengun.com/greddy/neodymium-magdrain
The following users liked this post:
JT2MA71 (05-15-19)
#510
I did Xpel or a similar high end product on full front, A pillars, roof, and spoiler, as well as rocker panels. If I had it to do over again, I would have dropped the $$ and protected my entire car. I ended up with a rock chip about an inch above the coverage in front of my rear wheel. Murphy's law...
The following users liked this post:
BossMoss (05-15-19)