fireguy596

I have a 2000 RX300 front wheel drive. I do not have a factory master key and didn't want to pay Lexus to get a new one so I bought this after market key fob with remote start and keyless entry. I have some basic electrical knowledge and have taken most of the dash apart on other projects, but am not sure that I know what I am doing here. I found a couple of Youtube videos, but would appreciate any advice from all of you before I get started. I plan on working on this next weekend.
Thanks,
Fireguy

salimshah

Please read up on

Engine imobilizer, You need a recognized/registered key in the vicinity of the ignition switch to allow generation o spark. [in absence of a registered key, the starter will engage but the engine would not run.]

Salim

fireguy596

I have a key that works, just not with the buttons to unlock the doors.

fireguy596

Does anyone have the electrical schematic for the wiring for the door lock actuator?

hypervish

You may be able to find it here: http://www.revbase.com/BBBMotor/Wd

fireguy596

http://alarmsellout.com/support/diag...01998-2003.pdf

fireguy596

Salimshah – Thanks, I understand now what you meant by needing a key. That will be another $70 that I wasn't counting on.

Hyperfish – Thanks for the info.

salimshah

You will need a master key to register another key. You can get an after market key for less than 70, but your bigger issue is processing a master key. You will be in home stretch if the current key you have is a master key.

Salim

Bobster999

I installed a different brand and found it all to be complex and frustrating to make it all work. I didnt keep the details on everything but you will find it challenging even if u have some electrical skills.

salimshah

Well said Bobster999. When I stated home stretch it really is theoretically possible. There are so many details afterwards to work through.

Salim

Bobster999

I found the remote locks to be the hard part. Remote start part was fairly simple. However, i do enjoy having it though.