Control blower motor - heat resister rx300
#1
Driver School Candidate
Thread Starter
Join Date: Sep 2011
Location: NY
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Control blower motor - heat resister rx300
Could anyone confirm this: I ordered control blower motor for rx 300 - 2001
the part that came is 87165-22050.
The motor taken out of the car was 87165-22040.
Is 87165-22050 IS GOING TO FIT THE SAME AS 87165-22040?
Thank you.
the part that came is 87165-22050.
The motor taken out of the car was 87165-22040.
Is 87165-22050 IS GOING TO FIT THE SAME AS 87165-22040?
Thank you.
Last edited by sylvia; 05-04-17 at 06:23 PM.
#3
Driver School Candidate
Thread Starter
Join Date: Sep 2011
Location: NY
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
heater resister for rx 300 2001
Please id someone can help
I would like to know if part # TOYota control blower motor - 87165-22050 is going to work on my RX 300 2001? Thank you
*** This has been answered ** [salim]
I would like to know if part # TOYota control blower motor - 87165-22050 is going to work on my RX 300 2001? Thank you
*** This has been answered ** [salim]
Last edited by salimshah; 05-07-17 at 06:17 PM.
#5
It will work. https://www.clublexus.com/forums/gs-...igh-speed.html
If you are a fatty and can't get in there to unscrew the old one you can just unclip the wires and clip them into the new unit. Then get some velcro or zip ties and just hang the thing out of the way, someplace where it won't rattle around.
If you are a fatty and can't get in there to unscrew the old one you can just unclip the wires and clip them into the new unit. Then get some velcro or zip ties and just hang the thing out of the way, someplace where it won't rattle around.
#6
Moderator
It will work. https://www.clublexus.com/forums/gs-...igh-speed.html
If you are a fatty and can't get in there to unscrew the old one you can just unclip the wires and clip them into the new unit. Then get some velcro or zip ties and just hang the thing out of the way, someplace where it won't rattle around.
If you are a fatty and can't get in there to unscrew the old one you can just unclip the wires and clip them into the new unit. Then get some velcro or zip ties and just hang the thing out of the way, someplace where it won't rattle around.
Salim
Thread
Thread Starter
Forum
Replies
Last Post
BluesImage
LS - 1st and 2nd Gen (1990-2000)
1
05-12-14 10:40 AM