Need help asap brake failure
#16
Moderator
Warning light method is:
use a fused jumper to bridge DLC1 [rectangular DIAGNOSTIC port [in the engine bay] pins E1 to Tc OR on DLC2 connector Tc to E.
Turn ignition ON ... ABS or Trac light will begin to flash and give you the error code.
4sec pause- First Digit Error code # flash -- 1.5 sec pause --- Second Digit code # flashes
2.5 sec Puase
sequence of flashes for additional error codes or repeat of the single error.
If every thing is fine --> 2 sec pause -> blip every .25 sec [no elongated pauses].
Salim
Thread
Thread Starter
Forum
Replies
Last Post
Caniac14
LS - 1st and 2nd Gen (1990-2000)
6
08-29-14 10:11 PM