Rear Marker Light - How to Remove/Re-install
05-22-22, 09:42 AM
#31
Simple Replacement
Great information and time plus $$ savings from everyone!
I ordered Marker Light from dealer and then, since I was fixing my daughter’s car at college and didn’t have tools with me, was able to borrow 1/4 10mm socket, Universal Joint and 10” Extension from Advanced Auto Parts.
Just using 10mm socket with the Universal Joint at 90 degrees I was able to get enough torque to remove the bolt. Tips on rotating lamp and bolt end first removal was great.
My hardest part was getting bolt lined up again due to a clip washer that kept slipping over hole.
I ordered Marker Light from dealer and then, since I was fixing my daughter’s car at college and didn’t have tools with me, was able to borrow 1/4 10mm socket, Universal Joint and 10” Extension from Advanced Auto Parts.
Just using 10mm socket with the Universal Joint at 90 degrees I was able to get enough torque to remove the bolt. Tips on rotating lamp and bolt end first removal was great.
My hardest part was getting bolt lined up again due to a clip washer that kept slipping over hole.
The following users liked this post:
Margate330 (05-22-22)
05-22-22, 08:41 PM
#32
Lexus Test Driver
Great information and time plus $$ savings from everyone!
I ordered Marker Light from dealer and then, since I was fixing my daughter’s car at college and didn’t have tools with me, was able to borrow 1/4 10mm socket, Universal Joint and 10” Extension from Advanced Auto Parts.
Just using 10mm socket with the Universal Joint at 90 degrees I was able to get enough torque to remove the bolt. Tips on rotating lamp and bolt end first removal was great.
My hardest part was getting bolt lined up again due to a clip washer that kept slipping over hole.
I ordered Marker Light from dealer and then, since I was fixing my daughter’s car at college and didn’t have tools with me, was able to borrow 1/4 10mm socket, Universal Joint and 10” Extension from Advanced Auto Parts.
Just using 10mm socket with the Universal Joint at 90 degrees I was able to get enough torque to remove the bolt. Tips on rotating lamp and bolt end first removal was great.
My hardest part was getting bolt lined up again due to a clip washer that kept slipping over hole.
Thread
Thread Starter
Forum
Replies
Last Post
quang3is
IS - 3rd Gen (2014-present)
4
03-17-14 12:54 AM
