shikbas

thank you all,i will appreciate any input about the leds for the brake lights,blinkers ,backup lights

normi2k5

Ah man... I went for the blinding look =D. Tried to make it as bright as possible. I went with 16 smd 31mm for the 2 domes. And including the three trunk lights as well. 6 smd is bright enough. I put those in a friends car since the ones i ordered wouldn't fit in the vanity mirrors =/ .

sail7seas

I replaced the right rear running light with a LED on lift-gate, and the right HID headlamp would go out.
Then I used a low amp replacement bulb, recall 161(1watt). and the right HID would go out intermittently.
So I changed to a published 2825 (5watt) right rear running light, and HID headlamp works again.

normi2k5

T10 42 SMD LED


T10 42 SMD LED (Parking Light)


T10 42 SMD LED (Parking Light)


T10 42 SMD LED (Parking Light)


T10 42 SMD LED (Parking Light)


Parking Light + Low beam (FOGS HAVE NOT BEEN CHANGED)



9006 68 SMD LED FOG


FOG


31mm 16 SMD LED FESTOON


Interior


Interior




3x 31mm 16 SMD LED It's Really not this bright. Camera illuminated the picture a bit.


T10 42 SMD LED Backup/Reverse +
T10 42 SMD LED TAIL LIGHT


T10 42 SMD LED Backup/Reverse +
T10 42 SMD LED TAIL LIGHT

satz

Were there any problems with the courtesy light leds not dimming or not switching completely off?

I've read of that happening, but not sure ehat leds they were?

shikbas

no problem here like that,36 leds board used

normi2k5

Same no problems.

koval

Hi, can U tell me which leds did u use for your fog lights and DRL lights?

normi2k5

Fog: 9006 (68 leds)

DRL: 9005 SYLVANIA Ulra highbeam