gas cap door removal
#1
Racer
Thread Starter
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
My gas access door is crooked and rubbing up against some paint on my car. it's been like this since i purchased it. Is there an easy way to remove the door and adjust it ? It seems like i can just remove two rubber grommets and there will be screws underneath?
#2
Driver School Candidate
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
On my 2005 I had to drill out the two rivets that hold it in place. I then purchased the rivets from lexus and replaced with a new assembly. The door is non-adjustable. Mine was too bent up to fix. Be aware that you will need a rivet gun that can handle 1/4" rivets.
Hope this helps
Hope this helps
Last edited by cmontel727; 08-25-13 at 03:15 PM.
#4
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Mine was out of adjustment too and wasn't closing flush with the surrounding metal. Seems like a rather flimsly and cheap gas door compared with other cars I've had. Like Rainbird (above), I just bent it by hand and it fits flush now. Lexus should be ashamed of themselves for such a cheap filler door.
#6
Driver School Candidate
Join Date: Sep 2019
Location: illinois
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
On my 2005 I had to drill out the two rivets that hold it in place. I then purchased the rivets from lexus and replaced with a new assembly. The door is non-adjustable. Mine was too bent up to fix. Be aware that you will need a rivet gun that can handle 1/4" rivets.
Hope this helps
Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
Devor
SC- 1st Gen (1992-2000)
3
03-22-11 01:29 PM