Need a clip, but don't know part number -help!
#1
Driver School Candidate
Thread Starter
Need a clip, but don't know part number -help!
Long story short- my dad pulled the wires out of the clip to my camshaft position sensor during a spark plugs change. The sensor itself is just fine but we need a new clip and wires. Called Lexus dealership 3 days in a row and they have no idea what it is.. which in itself confuses me lol.
I have a 2008 RX350. Can anyone help me find a part number for this? They say it's a 5 digit number but all I'm seeing is a 9 digit number and Lexus can't find it.
I have a 2008 RX350. Can anyone help me find a part number for this? They say it's a 5 digit number but all I'm seeing is a 9 digit number and Lexus can't find it.
#2
Lexus Test Driver
Hi nizmoz,
I see this is your 1st post so... Welcome to club lexus~~!
I see this is your 1st post so... Welcome to club lexus~~!
#3
Lexus Test Driver
They call it VVT sensor connector.
Im assuming its Bank 1 Exhaust side that you need?
3 pin wire, Black connector?
Connector part # 90980-12352
Wire harness part # 82998-24250
Im assuming its Bank 1 Exhaust side that you need?
3 pin wire, Black connector?
Connector part # 90980-12352
Wire harness part # 82998-24250
The following users liked this post:
Nismoz (02-15-20)
#4
Driver School Candidate
Thread Starter
Thank you!
After some looking around I see a lot of the ES model owners have done the same. They say their part code for the connector is 90980-(5 more digits), would the last 5 refer to the model?? I seen two separate posts with different numbers on the last 5 digits
After some looking around I see a lot of the ES model owners have done the same. They say their part code for the connector is 90980-(5 more digits), would the last 5 refer to the model?? I seen two separate posts with different numbers on the last 5 digits
#5
Driver School Candidate
Thread Starter
lol it is bank 1 but we spliced the bank 2 clip into bank1 so we could put the intake manifold and the res of it together. yes its the 3 pin black connctor. and when we started it up only bank 2 threw a code so the splice worked.
Thread
Thread Starter
Forum
Replies
Last Post