Phone Holder?
#18
I just checked mine and found that the trim moves very slightly if I put a lot of force on the mount. It doesn't move enough to be of concern. After 4,200 miles, I'm very happy with the mount. I have a Galaxy S21u and my partner has a similar sized I-Phone.
#19
#22
Used to have a Pro Clip that attached to the far side of the console trim on my 2014 Infinti Q50. It was solid and attached easily. I think our console edge would also be suitable but they don't make one for that location.
#24
#25
Oh this is what I was planning to get. I'm wondering if the MagSafe/magnetic mount which requires the phone to be stuck to and pulled away constantly is causing this to happen. As opposed to have a basic holder where the phone just rests and the removal doesn't result in a "pull away" force ...
#26
I am thinking of getting this for my wife's 2024 RX. 1) Where the mount attaches to the vent, is there a tape/adhesive that holds it in place or is somehow force locked physically? 2) Does it block the vent controls? 3) I am thinking of getting it with the wireless QI charger phone mount for my wife's iPhone, the mount you have got doesn't charge correct?
2) It doesn't block the vent controls or air flow if the vents are aimed toward driver and passenger, respectively.
3)My mount does not charge. I personally don't like wireless chargers because they cause the battery to heat up more than wired chargers, thus shortening their life. I keep my phones a long time though, often four years.
I'm up to 7,700 miles on the mount with zero issues. There is a Galaxy S21 Ultra or an iPhone 13 Pro Max in it anytime the vehicle is being driven.
Last edited by WellsB; 02-02-24 at 08:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post