Veritek's SC Debut
08-14-06, 10:44 AM
#31
Lexus Champion
Join Date: Jan 2003
Location: GA
Posts: 2,537
Likes: 0
Received 0 Likes
on
0 Posts
OK, everyone else has given their opinion so I guess here goes. Firstly, kudos for doing something different. You went out on a limb and if you are happy with it then that is all that matters.
I have the same problems with it as everyone else - Konigs are cheap crappy wheels ( used to have the exact ones on my Legend). They bend over the slightest bump. A set of IS300 or IS350 wheels would look a lot better.
The mesh does look terrible. You can't have that big of a gap and not have an IC poking through. Personally I would have waited until I had the turbo setup before doing the work.
The front bumper needs a lot of work and I think your bodyshop could have done a lot better job.
The car has great potential though - you should take advantage of that
And most of all - you have come on here and maturely taken criticism - which is more than I can say for most members. For that -
Jonny
I have the same problems with it as everyone else - Konigs are cheap crappy wheels ( used to have the exact ones on my Legend). They bend over the slightest bump. A set of IS300 or IS350 wheels would look a lot better.
The mesh does look terrible. You can't have that big of a gap and not have an IC poking through. Personally I would have waited until I had the turbo setup before doing the work.
The front bumper needs a lot of work and I think your bodyshop could have done a lot better job.
The car has great potential though - you should take advantage of that
And most of all - you have come on here and maturely taken criticism - which is more than I can say for most members. For that -
Jonny
Last edited by veritek; 08-14-06 at 10:49 AM.
Thread
Thread Starter
Forum
Replies
Last Post
