Any pics of a Vertex SC with 400 lip on the 97 bumper?
#1
Driver
Thread Starter
Join Date: May 2008
Location: San Jose, California
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Any pics of a Vertex SC with 400 lip on the 97 bumper?
I currently have the Vertex replica kit on my SC, but without the front kit. I'm only using the stock 97 front bumper as of now, and looking to adding a lip to it. I've thought about the Genuine Vertex lip 2 weeks ago, but it's just too expensive (AT LEAST 500 SHIPPED). And also, some idiot out there may decide to rip it off the following night, but then realizing he can't use it either because the fiber glass would snap into pieces. In the end, none of us can keep the lip. That's how some of those idiots flock people over for good, because you won't dare to put on another Vertex lip afterwards. God, I'm just a little angry because I read another thread earlier with some dudes car being broken into, and his touch screen got stolen.
But in any case, I'm thinking about going with the SC400 lip, and extending it so that it fits the 97 bumper. It should look pretty clean, but I'm not sure if it would match the Vertex sides. Any pictures of this setup people?
But in any case, I'm thinking about going with the SC400 lip, and extending it so that it fits the 97 bumper. It should look pretty clean, but I'm not sure if it would match the Vertex sides. Any pictures of this setup people?
#3
Driver
Thread Starter
Join Date: May 2008
Location: San Jose, California
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
I saw that already, but right on for trying to help. I'm actually hoping to see a Vertex kit with the front 97 bumper attached to a sc400 lip. Again, I wanted to see if the smaller lip would balance out with the side skirts.
Your car is sick too Baoser..
Your car is sick too Baoser..
#5
Driver
Thread Starter
Join Date: May 2008
Location: San Jose, California
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
joeazy187
SC400 / 300 Classifieds
1
05-01-11 10:14 AM