my sc300 project drag car is finally done!! (with pics)
09-24-08, 08:39 PM
#1
my sc300 project drag car is finally done!! (with pics)
first off i would like to thank josh dan and mike at first state motorsports, kooch at galpin auto sport (gas), kennedy at platinum vip, eli eddings at eddings engine in san fernando ca, also, ken at sepulveda muffler in north hills ca. and dave jusko the help to get the car where it needed to be.
without the talent of the six above the car seriously would have never been finished. thank god i never sold the car or parted it out. i was really conisdering it a few times.
specs
2jzgte long block bored .40 over
virtual works th400 trans
trans cooler custom made by friend jake in NY
carillo h beams
boostlogic exh manifold
tial 44mm wastegate
precision 78gtsh with .96 hot side was (76gts)
4" turbo back exhaust
NX nos setup (150) shot
hypertune intake with fuel rail
3 fuel pumps with massive supply line
balanced crank
boost logic crank dampner pulley
ferrea +1mm oversize valves
ferrea double valve springs titanium retainers etc...
new head that was ported and polished by eddings
hks 272 cams
aem ems
1 piece driveshaft
TT auto rearend
titan solid diff mounts
CCW drag package
multi point safety cage
aluminum race seats
and the list goes on and on.
we will be retuning the car tomorrow for a better tune.
i have a few tricks up my sleve till its visually better looking in the interior, but it's basically done. i will be posting up vids from the track for all to see.
but again thanks to all who helped.
without the talent of the six above the car seriously would have never been finished. thank god i never sold the car or parted it out. i was really conisdering it a few times.
specs
2jzgte long block bored .40 over
virtual works th400 trans
trans cooler custom made by friend jake in NY
carillo h beams
boostlogic exh manifold
tial 44mm wastegate
precision 78gtsh with .96 hot side was (76gts)
4" turbo back exhaust
NX nos setup (150) shot
hypertune intake with fuel rail
3 fuel pumps with massive supply line
balanced crank
boost logic crank dampner pulley
ferrea +1mm oversize valves
ferrea double valve springs titanium retainers etc...
new head that was ported and polished by eddings
hks 272 cams
aem ems
1 piece driveshaft
TT auto rearend
titan solid diff mounts
CCW drag package
multi point safety cage
aluminum race seats
and the list goes on and on.
we will be retuning the car tomorrow for a better tune.
i have a few tricks up my sleve till its visually better looking in the interior, but it's basically done. i will be posting up vids from the track for all to see.
but again thanks to all who helped.
