swittie

Can anyone provide input on how difficult (tools, time, skill) it is to remove and replace a cracked high beam assembly?

thks much.

Jherb350

iTrader: (1)

In order to replace the whole assembly you'll need to remove the bumper. I would set asside about an hour if you have never taken off the bumber before.

Search for Bumper Removal and you'll find a step by step guide on how to remove it.

ekrebs

Taking off the bumper for the first time is a PITA just becuse there are a lot of clips running along the inside of the air dam!(opening)! once you get these clips out there are 2 nuts on the end of the bumper(both sides), then take of rubber gaurd piece running along the top, once thats off youll see about 5 or 6 screws, after the brace is off there will be more clips!

Hope this helps!

swittie

I will study the step by step and see if I have patience enough to do this. Thks guys

mm

portion

yea i did this a while back. The hardest thing for me was taking out the headlights.
as they are in there snug between the fender and the bumper. just kind off wiggle it out.
Once u get them out its pretty much smooth sailing... it was just a lot of screws.