Question : 92-96 v 97+ side molding
#1
Banned
Thread Starter
iTrader: (3)
Join Date: Sep 2008
Location: NA
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
Question : 92-96 v 97+ side molding
I removed that black strip below the scuff mark. Cut the molding on the side of the fender and rear quarter panel. Plus I removed the side molding on the fender and rear quarter. All this to fit the 97 rocket panel onto my 92 car. Its aligned perfect but when i look at it closely i can see a huge gap between the bottom of my door and the panel. It looks to me like the door molding should extend further downward. I just checked and it appears the the part #s are different as well.
Can someone with a 97+ oem car post a closed up pic to confirm this?
Can someone with a 97+ oem car post a closed up pic to confirm this?
Last edited by Ryeno; 06-01-09 at 02:12 AM.
#2
Pole Position
iTrader: (3)
I removed that black strip below the scuff mark. Cut the molding on the side of the fender and rear quarter panel. Plus I removed the side molding on the fender and rear quarter. All this to fit the 97 rocket panel onto my 92 car. Its aligned perfect but when i look at it closely i can see a huge gap between the bottom of my door and the panel. It looks to me like the door molding should extend further downward. I just checked and it appears the the part #s are different as well.
Can someone with a 97+ oem car post a closed up pic to confirm this?
Can someone with a 97+ oem car post a closed up pic to confirm this?
Thread
Thread Starter
Forum
Replies
Last Post
philliptie
SC- 1st Gen (1992-2000)
1
01-17-10 09:23 AM